Section 5 GPIB
5-22
3) OFSFRQ offset frequency
Sets the offset frequency.
Command : OFSFRQ n
Query : OFSFRQ?
Response : OFSFRQ n
<Program data>
Value of n
0 to Fmax (Hx)........................... Suffixes : GHZ, MHZ, KHZ, HZ, G, MA, K (Unit Hz)
Note : Fmax= 20 GHZ ............. MF2412B
27 GHZ ............. MF2413B
40 GHZ ............. MF2414B
4) OM output mode
Set this unit to the continuous output mode for numeric output format data used by the MF76 counter. The host
CPU can continuously read measurement data if you insert an Input statement (specify talk for this unit) after the
following command message.
Command : OM n
Query : OM?
Response : OM n
<Program data>
Value of n Setting
0 .......................... Outputs the latest measurement result generated by the data output request and specified as
talk by the host CPU Input statement.
Count operation
Talk specify
Data sending
1 .......................... The output request and frequency measurement timing of data generated and specified as talk
by the host CPU Input statement are synchronized. When the measurement result is not ob-
tained, the new measurement is not executed.
Count operation
Talk specify
Data sending
2 ................................................. Reverts to the IEEE 488.2 communication format.
To Next Page
Loading...