SH-300
Text Panel
Page 48 of 103
If the text and the position of the information in the screen need to be changed, cross “user menu
setting” check box and double click the text frame “NO ALARM INFORMATION”, the following
prompting frame will be displayed as the following:
In this property frame, user can modify the X and Y coordinate position of the menu information (at
the top left corner, it is the original coordinate position (0, 0) of X and Y) and the contents of the
text information of the text frame (supporting multi language system). If “Default” is selected,
which means the default interface will be displayed when communication. The displayed text is
“NO ALARM INFORMATION” and the coordinate position is X16 and Y24 as in the following
diagram:
Example: Substitute the text “alarm didn’t happen ” for “NO ALARM INFORMATION”. Then click
“OK”. The following diagram will be displayed:
Under actual operation, if there is no alarm happens, press “ALM” key, the following diagram will
also be displayed:
To Next Page
Loading...
