Light Gauge Metal Roof and Wall Panels Installation • August 2016 1
ASC Building Products
A Division of ASC Profiles LLC
Table of Contents
Section
Introduction ......................................2
Minimum Recommended Tools & Equipment . . . . . . . . 2-3
Delivery, Handling & Storage. . . . . . . . . . . . . . . . 3
Safety Considerations .............................3
Roof Preparation..................................4
Map of Typical Roof Conditions......................5
Trim Locations....................................6
Fastener Placement ...............................6
Fastener Selection ................................7
Panel Installation..................................8
Hip/Ridge Flashing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Universal Ridge Termination .......................10
Vented Ridge Flashing ............................11
Vented Ridge Termination .........................12
Valley Flashing ..................................13
Valley Termination ...............................14
Eave and Vented Eave Flashings ...................15
Eave Flashing Preparation.........................16
Gutter and Vented Gutter Flashing ..................17
Gable Flashing ..................................18
Gable/Ridge Transition............................19
Gable Corner at Eave.............................19
Gable Flashing Preparation ........................20
Gable Flashing Preparation at Ridge ................21
Peak Flashing ...................................22
Sidewall Flashing ................................23
Endwall Flashing.................................24
Vented Endwall Flashing ..........................25
Section
Slope Transition - High to Low Slope ................26
Slope Transition - Low to High Slope ................27
Chalet Gable Flashing ............................28
Adjustable Gable Flashing .........................29
Vent Flashing ...................................30
Vent/Pipe Flashing Installation Procedure . . . . . . . . 31
Skylight Flashing.................................32
Skylight Flashing (Side) ...........................32
Skylight Flashing (Uphill Side) ......................33
Skylight Flashing (Downhill Side) ...................34
Procedure for the Installation of
Skylight Flashings ............................35
Skylight Flashing Preparation ...................35-36
Chimney Flashing ................................37
Chimney Flashing (Side) ..........................38
Chimney Flashing (Uphill Side) .....................39
Chimney Flashing (Downhill Side)...................40
Valley Top End ..................................41
Valley Dormer ...................................42
Panel End Lap ..................................43
Sealing End Laps & Lapping the Hems ..............44
Window/Door Trim Corner Wall Detail ...............45
Base Trim, Wall Step, Panel Top Wall Detail ..........46
Inside Corner Wall Detail ..........................47
Outside Corner Wall Detail.........................48
Light Gauge Metal Roof & Wall Panels