ASC Delta Rib - Skylight Flashing; Skylight Flashing (Side)

32 August 2016
www.ascbp.com
Light Gauge Metal Roof and Wall Panels
Installation Guide for Delta Rib
™
, Delta Rib
™
III, Nor-Clad
®
, Strata Rib
®
& 2½ Corrugated
DOWNHILL
SEE PAGE 34
UPHILL
SEE PAGE 33
SIDE
SEE BELOW
1.
2.
3.
SLOPE
LENGTH
WIDTH
3 1/2"
2"
3/8" HEM
3.
DOWNHILL
SEE PAGE 37
WIDTH
LENGTH
SLOPE
1.
SIDE
SEE BELOW
2.
UPHILL
SEE PAGE 36
SIDE SKYLIGHT (SK18)
2. #14 WOOD SCREW
@ 4" O.C.
BUTYL MASTIC TAPE
ASC'S LIGHT
GAUGE ROOFING
Skylight Flashing
• Wherever possible, position the skylight curb so the ribs of
the roof panels do not interfere with the flashing.
• Cut the light gauge roof panels as close to the left, right
and downhill sides of the curb as possible. Cut the uphill
side 6" up from the curb as indicated above.
• Penetrations occurring over spaced supports require
additional support framing.
SK18
(Side)
1 – Skylight Flashing (Side)
Note: Do not fasten the
panels within 24" uphill
from the skylight until the
penetration flashing is
installed.