6 August 2016
www.ascbp.com
Light Gauge Metal Roof and Wall Panels
Installation Guide for Delta Rib
™
, Delta Rib
™
III, Nor-Clad
®
, Strata Rib
®
& 2½ Corrugated
Prevailing WeatherSheeting Direction
Neoprene or
Butyl Mastic (Typ)
Nor-Clad
®
(36" Coverage)
Strata Rib™ (36" Coverage)
Delta Rib III (36" Coverage)
Delta Rib (24" Coverage)
2-1/2" Corrugated (24" Coverage) Wall Applications
2-1/2" Corrugated (21-1/3" Coverage) Roof Applications
Lap Stitch Screw (Typ)
Woodscrew (Typ
or
Fastener Placement
Trim Locations
EAVE FLASHING
BOTTOM
CLOSURE
SINGLE TRACK
COVER
DOUBLE TRACK
COVER
MATCHING
FIBERGLASS
JAMB
TRIM
UNIVERSAL
ENDWALL
GABLE TRIM
UNIVERSAL
RIDGE
UNIVERSAL
SIDEWALL
TOP CLOSURE
PIPE FLASHING
BASE
TRIM
OUTSIDE
CORNER
C-METAL
INSIDE
CORNER
MAXIMUM RECOMMENDED
FASTENER ROW SPACING*
1
⁄2" Plywood 36"
5
⁄8" Plywood 42"
2" x 4" 36"
Notes:
Lap panels away from prevailing weather. Use only those accessories specifically designed for use with this product. Use only
galvanized or ZINCALUME
®
-coated fasteners. Isolate roofing and flashings from contact with dissimilar metals. Fastener selec-
tion will vary based upon - see chart on following page. The use of neoprene or butyl mastic tape along the sidelaps, as shown
above, is always recommended for roofs. Lap stitch screws should be placed at 16" o.c. maximum.
*The maximum recommended fastener row spacing applies to mild weather conditions of 110 mph winds and an exposure rating
of “B” (protected) for typical buildings and substrate. For project specific wind uplift attachment, contact your ASC representative.
To Next Page
Loading...