ASCOM D81 User Manual

TD 92644EN
User Manual
Ascom d81 DECT Handset
5 Calling
39
18 June 2018 / Ver. K
5.1.1 Answer a Call
When the signal sounds press or the "Accept" soft key to answer the call. The call can
be answered in loudspeaking mode by pressing the soft key. The name or number of
the calling party is displayed if calling line information is available.
TIP: When a headset is connected to the handset, the headset button can be used to
answer the call. In addition, it is possible to configure the headset button with a specific
function, such as hook off, dial last called number, or dial a predefined number. See the
handset’s Configuration Manual.
A call may also be answered in the following ways:
• Automatically and Loudspeaking: When Automatically is enabled, all incoming calls are
connected automatically. See 7.8 Settings on page 72.
• With a predefined message. This lets the use decline the call, but still acknowledge its
receipt, by sending a predefined text message to the caller. See 11.7.2 Answering a Text
Message with a Predefined Message on page 93.
5.1.2 End a Call
A press on ends the call. The duration of the call is shown in the display. The total time of
the call can also be retrieved from the Calls menu > Call time.
A call can also be ended by putting the handset in a charger. Note that all ongoing calls are
disconnected. See 7.9.4 In Charger Action when in Call on page 85.
NOTE: Some systems/PBXs require that the handset sends a DTMF to end a call. See the
handset’s Configuration Manual for more information.
5.2 Outgoing Call
5.2.1 Pre-Dial
Enter the number and press to get the line. The number is shown on the display while
dialling. If needed, press "Clear" to erase the number. By using the navigation key it is
possible to step and add or delete a digit in a number.
The tone sender in a pre-dialed number can be turned on by long pressing .
An international number can be dialled from the handset by entering a + character followed
by the country code and local number. To enter the + character, long press the 0 key until
the character is shown in the display.
NOTE: The + character cannot be entered and international numbers cannot de dialled in
the following circumstances:
• If the 0 key has been configured as a hot key.
• If the handset has been set up to perform advanced functions normally used by a system
administrator, as described in 10.1 Admin Menu on page 88.

ASCOM D81 Specifications

General

Brand	ASCOM
Model	D81
Category	Handsets
Language	English