ASCOM D81 User Manual

TD 92644EN
User Manual
Ascom d81 DECT Handset
7 Menu Operation
66
18 June 2018 / Ver. K
6Press "More".
7 Select "Save number".
8 Select "Work Number", "Mobile number", or "Other number".
9 Press "Add".
10 Enter name. See 2.1.2 Alphanumeric Keys on page 14.
11 Press "OK".
12 Press "Save". The number is saved in the contact list.
7.4.2 Write New Messages
A message can be constructed from scratch, or from a predefined template that can be
used as it is or edited. For additional information about message templates, see 11.7
Message Templates on page 92 . The maximum message length is normally 160 characters
but may be less depending on the character set used.
The first character entered is always upper-case, followed by lower-case character.
However, this may be overridden by pressing the * -key before entering the character.
When pressing a key, the first available character for that key is displayed, see See 2.1.2
Alphanumeric Keys on page 14. To enter the other characters supported by the key, press
the key until that character appears in the display.
The keys 0-9, * or # can be used. Keys 0 and 1 contains special characters, see See 2.1.2
Alphanumeric Keys on page 14 to see all characters.
For example, to enter the character E, press key 3 twice. "E" appears in the display and is
selected after a timeout or when another key is pressed.
TIP: If the system supports UTF-8 character encoding, the input language can be changed
temporarily by long pressing . This can be used to temporarily access characters in a
foreign language.
To delete a character, press "Clear".
To construct and send a message, perform the following steps:
1 Enter the menu by pressing "Menu".
2 Select in the menu.
3 Select "Write new message".
4 Write the message from scratch or select a message template by pressing the "More"
soft key and, if required, edit the message as described in 11.7.1 The Templates Menu
on page 93.
NOTE: The "More" key is not displayed if no message templates have been defined.
5Press "Send".
NOTE: A message can be saved and sent later by pressing the soft key "Back" and
select "Yes". The message is stored under Unsent messages. See 7.4.3 Unsent
Messages.
6 Enter number, or press to access contacts in the local phonebook and the
company phonebook.
7Press "Send".

ASCOM D81 Specifications

General

Brand	ASCOM
Model	D81
Category	Handsets
Language	English