TD 92644EN
User Manual
Ascom d81 DECT Handset
7 Menu Operation
80
18 June 2018 / Ver. K
7.8.9 Change Owner ID
The Owner ID is set to identify the handset.
1 Enter the menu by pressing "Menu".
2 Select in the menu.
3 Select "Owner ID".
4 Enter name/identity. See 2.1.2 Alphanumeric Keys on page 14.
5Press "Save".
7.8.10 Alarm Settings
Tip: It is recommended to configure a shortcut to this menu if it is frequently used, see 7.7
Shortcuts on page 71.
NOTE: This menu is applicable for d81 Protector only.
Activate alarm
1 Enter the menu by pressing "Menu".
2 Select in the menu.
3 Select "Alarm".
4 Select "Activate alarm".
5 Select "Pull-cord"
1
, "Man-down", and/or "No-movement".
6 Press "Select" to change the setting. The check box is marked.
7 Press "Back" to save the setting. To remove the setting, press "Select". The check
box is unmarked.
When an alarm is activated, the corresponding alarm icon is show, see Table 8 on page 80.
Figure 8. Alarms icons
The Man-down alarm and No-movement alarm can temporarily be disabled during calls to
avoid sending false alarms when the user tilts the handset or not moves during the call. If
the Man-down alarm and No-movement alarm are disabled during calls, the corresponding
icons are not displayed.
NOTE: See also Configuration Manual, Ascom d81 DECT Handset, TD 92674EN for
additional settings and 6 Alarm Operation on page 46.
1.Requires a functionality license.
Pull-cord alarm
Man-down alarm
No-movement alarm
To Next Page
Loading...
Need help?
General
