TD 92644EN
User Manual
Ascom d81 DECT Handset
2 Descriptions
14
18 June 2018 / Ver. K
2.1.1 Hot Keys
The keys "0" and "2" to "9" can be configured as Hot Keys. A long press on any of these
numbers in idle mode is, by default, a shortcut to the Call contact list. The list is in alphabetic
order and depending on which key is pressed is dependent on where in the list the contact
appears.
A Hot Key can be programmed to give access to frequently used functions such as dialling
a specific number, a shortcut on the menu, or sending an SMS. See 7.7.2 Define Hot Keys
on page 71.
2.1.2 Alphanumeric Keys
NOTE: Depending on the selected menu language and character setting in the IMS3/Unite
CM, other characters can be available. This means that the character order can differ from
the figure below.
14 Off-hook key
To answer a call, to pre-dial a number, and as a shortcut to the Call
list.
15 Soft keys
The three Soft keys are located just beneath the display and the
function of each Soft key is indicated by text in the display just
above the keys. In idle mode, the middle and right Soft key can be
used for specific functions defined by the user of the handset. See
7.7.1 Define Soft Keys on page 71.
16 Mute and PTT button
A long press on the Mute button in idle mode, changes between
ring signal on/off. At incoming call, a long press on the Mute button
silencing the ring signal.
During a call, a long press on the button changes between
microphone on/off.
Note: A muted handset still sounds an alert, a beep, when there is
an incoming call.
17 Volume button (down)
To decrease the speaker earpiece, headset, and the loudspeaker
volume. The button is placed on the upper left side of the handset.
18 Volume button (up)
To increase the speaker earpiece, headset, and the loudspeaker
volume. The button is placed on the upper left side of the handset.
19 LED
Indicates incoming call, messaging, low battery, and charging.
a. This is a system dependent feature.
To Next Page
Loading...
Need help?
General
