TD 92483GB
2008-06-05/ Ver. B
Installation and Operation Manual
UPAC- Unite Packet for Messaging and Alarm
40
1 Click “Setup” for the module whose supervision settings should be changed.
2 Enter the following settings.
3 Click “Save”.
Figure 55.
Settings Description
Supervised: If module/equipment should be supervised or not.
Interval: The time between supervision request.
Level: The fault level to use in the Status Log.
Event Description: A customized description that will be added to the Status Log.
Interface
Description:
A customized description of the service.
To Next Page
Loading...