ASEM HMI30 - Cut-Out Measures; Degrees of Protection; Figure 21 HMI30 5.7 Cut-Out; Figure 22 HMI30 5.7 Cut-Out

25
HMI30 / HMI30-TF User’s guide
Figure 21
HMI30 5.7” cut-out
Figure 22
HMI30 5.7 cut-out”
Figure 23
HMI30 5.7” cut-out
3.6.1 Degrees of protection
The degrees of protection of the system are guaranteed only if the following con-
ditions are satisfied:
 Material thickness at the mounting cut-out for IP65 protection: 2mm to 4
mm.
 Deviations of the plane of the mounting cut-out limits: ≤ 0.5 mm.
This condition must be satisfied even when the HMI30 is installed.
 Allowed surface roughness in the area of the seal: ≤ 120 microns (Rz 120).
3.6.2 Cut-out measures
3.6.2.1 5.7” cut-out
3.6.2.2 7.0” wide cut-out
3.6.2.3 8.4” cut-out