Aspen Avionics EFD1000 - Page 210

EFD1000 Installation Manual
DOCUMENT # A-01-126-00 PAGE 210-225 Revision H
© Copyright 2009 Aspen Avionics Inc.
EFD1000 Installation Final Check Sheet
(page 2 of 4)
SECTION POST INSTALLATION TESTS PASS FAIL
10.5.4 Heading Accuracy Check
10.5.5 Heading Interference Test
10.6.1 Indicated Airspeed Test
10.6.2 Altitude Display Test
10.6.3 System Leak Test
10.6.4 OAT- Outside Air Temperature Test
10.6.5 AHRS (attitude solution) Test
10.6.6 GPS Sensor Test - GPS1 (if installed)
10.6.6 GPS Sensor Test – GPS2 (if installed)
10.6.6 RSM GPS (Back-up) Sensor Test
10.6.7 NAV Receiver Sensor Test – NAV1 (if installed)
10.6.7 NAV Receiver Sensor Test – NAV2 (if installed)
10.6.8 Back-up NAV Indicator Test (if installed)
10.6.9 Autopilot Sensor Test (if installed)
10.6.10 Flight Director Test (if installed
10.6.11 Sonalert Test (if installed)
10.6.12 Decision Height Test (if installed)
10.6.13 Ancillary Equipment Heading Check (if connected)
List equipment interfaced:
10.6.14 TAPES Configuration Check
10.6.15 EMI Test
10.6.16 Flight Control Interference Check
10.6.17 Internal Battery Test (the EFD is normally shipped with the
internal batter disconnected)
6.4 Weight and Balance performed
7.4 Electrical Load Analysis performed
11 Post Installation Flight Test
11.4 Document successful completion of flight test in aircraft log
book per FAR 91.407B