Ch. 10. Environmental Scanner Overview Sec. 10.3. Cypher ES Quick Reminder List
4.
Warning: Be careful to avoid touching the fragile piezo wires.
Hold the cantilever holder only by its handles.
• Hold the cantilever holder only by its two plastic handles (upper image).
• In particular, avoid contacting the wires running to the tapping piezo (lower image).
• Be careful not to scrape the piezo wires when tightening the right side cantilever
holder locking screw.
Warning: Pay attention! The piezo wiring is very fragile. Be careful not to touch it.
5.
Always power off the microscope before
exchanging scanners.
• Before exchanging scanners, remember
to first motor the objective to its upper
limit of travel.
• Then power off the controller before
disconnecting the scanner.
• Exchange scanners and then power the
controller back on after the new scanner
has been reconnected.
Warning: Pay attention! On older Cyphers,
exchanging the scanner while the system is
powered up can damage the backpack
electronics.
DRAFT
Page 124
To Next Page
Loading...