Ch. 18. Laser Sources Sec. 18.4. Troubleshooting
7.
Close right enclosure door:
• Close the right enclosure door.
• While pressing it firmly closed to
compress the rubber seal, install the two
screws at bottom of the door. These
screws were removed in
Step 6 on
page 199
.
8. Install the upper screw on the right hand door (removed in Step 7 on page 199).
9. Install the upper screw on the left hand door (removed in
Step 8 on page 199).
10. Install the four rear screws (removed in
Step 5 on page 199) into the top cover.
11.
Replace View System bracket:
• Replace the bracket in front of the view
system.
• Tighten the screws.
BETA
Page 202