Ch. 21. Shipping or Moving Sec. 21.4. Shipping a Complete Cypher AFM System
1. Undo the HDMI cable from the back of the chassis (The stiff blue ribbon cable).
a) Slide the AFM chassis about 1-2 inches forward.
b)
Put your hand down between the chassis
and the enclosure back wall and grip the
blue ribbon cable at the center of the
picture.
c) Release the cable from the chassis by pinching its sides and pulling down.
2. Undo the Heater Cable (Brown & Blue Cable on the side)
a) Slide the chassis to the left about 1-2 inches.
b)
Place your hand down the right side of
chassis and grip the white connector.
c) To release this cable from the chassis there is a catch on the latch of this cable – squeeze the
bottom side of it and wiggle loose to release.
3.
Remove the chassis from the enclosure using
the handles on either side of the
chassis-CAREFUL IT IS HEAVY! Use all
your fingers to lift it (not like the picture!).
4. Set it aside on a safe, hard surface. We will return to the chassis/head in Section 21.4.7 on
page 254.
BETA
Page 247
To Next Page
Loading...