Ch. 21. Shipping or Moving Sec. 21.4. Shipping a Complete Cypher AFM System
10.
a) Place the objective in the round hole in
the view module foam and push it all
the way in; the lid should be flush with
the top of the foam.
b) Put the chassis/optics cover in the view
module foam (a part that was taken off
the front of the chassis before).
c) Put the airflow shield in the view
module foam (a part that was taken off
the front of the chassis before).
11.
Place the motor power supply with the power
cord inside the view module foam, parallel to
the view module itself.
12. Put on the top foam; make sure the square hole lines up with the corner where the view module
piece sticks up.
13.
Bag Pass through Board in Anti-Static Bag
(part taken from Backpack & Chassis) and
put in top hole of foam
14. Coil the black FireWire cable in the top. Pass it through the board.
15. Close the box and tape it shut.
21.4.7. Chassis: Packaging
STOP!! Call or otherwise contact Asylum Research and talk to us before moving anything. Chances
are that with a few phone calls and the help of this chapter you can do the job yourself. Not calling us
will likely result in instrument damage, costly repairs and downtime, and the voiding of your warranty.
BETA
Page 254
To Next Page
Loading...