15
Changing passwords
1. Touch "PASS (a key
symbol) .”
2. Type in the current password
and touch "ENTER.”
3.
Type in a new password twice
and touch "ENTER."
About the administrator password
※ Change the factory default administrator password as soon as possible. As the default password is
available in the manual, anyone can easily alter the settings.
Matters concerning all users
※ When a wrong password is entered, "WRONG PASSWORD" will be displayed.
※ Each password must be unique to the user. If a password is rejected while following the correct
procedure to set a password, the password may have already been taken by another user.
Matters concerning the administrator
※ The password will remain the same after the user name has been changed.
※ If the user name had been left blank when "ENTER" was touched, the name will be reset to the factory
default name. However, the password will remain the same.
※ Please contact ATAGO if the password has been lost.
Matters concerning registered and guest users
※ If a user name had been left blank when "ENTER" was touched, the user information will reset to none.
※ A password cannot be set without first registering a user name.
※ A registered password will reset to none once the user name is changed.
To Next Page
Loading...
Need help?
General
