58
•
Data Items Saved in USB Flash Drive
(* Items saved when "RESULT" is selected. See page 41 "Saving Data on USB Flash Drive".)
Name Details
*
Date Date of measurement
*
Time Time of measurement
*
Scale Name of scale used ("ZERO" for zero-setting)
*
Brix Measurement value in Brix. Blank when in error
*
nD Measurement value in nD
*
Conc Measurement value in user scale
*
Unit Unit of measurement
*
Temp Temperature at the time of measurement
*
Result OUT OF RANGE, OUT OF SCALE, ZERO SET END, OUT OF WATER, etc.
*
Sample Sample name on the measurement screen
*
ID User ID on the measurement screen
*
Mode MODE-1, -2, -3, -S, or T (T is only available for 5000i-Plus)
*
T.Temp Target temperature. Blank when Peltier is turned off
*
L.Lo Lower limit
*
L.Hi Upper limit
*
n Number of continuous measurements
WT Wait time
DP Resolution
nD1 The first refractive index value in a conversion table for a user scale.
nD2 The 2nd refractive index value in a conversion table for a user scale.
nD3 The 3rd refractive index value in a conversion table for a user scale.
nD4 The 4th refractive index value in a conversion table for a user scale.
nD5 The 5th refractive index value in a conversion table for a user scale.
Data1 The first concentration data point in a conversion table for a user scale.
Data2 The 2nd concentration data point in a conversion table for a user scale.
Data3 The 3rd concentration data point in a conversion table for a user scale.
Data4 The 4th concentration data point in a conversion table for a user scale.
Data5 The 5th concentration data point in a conversion table for a user scale.
S.Date Date of scale setting
S.Time Time of scale setting
S.ID User ID used for scale setting
Z.Date Date of the latest zero-setting
Z.Time Time of the latest zero-setting
Z.Temp Target temperature of the latest zero-setting
Z.ID User ID used for the latest zero-setting
MC.Date Date of manual calibration
MC.Time Time of manual calibration
MC.Scale Scale (Brix or nD) used for manual calibration
MC.RVal Measurement value of manual calibration
MC.Sval Adjustment value of manual calibration
MC.ID User ID used for manual calibration
DT.BDate Date before the change
DT.BTime Time before the change
DT.ADate Date after the change
DT.ATime Time after the change
To Next Page
Loading...
Need help?
General
