55
•
Viewing Settings List from SCALE Screen
Setting Details Factory default
SCALE TYPE Choose from Brix, nD (refractive index), user,
or special scales.
#001 = Brix
#002 = nD
SCALE NAME Enter up to 10 characters (only for user
scales).
#001 = "Brix"
#002 = "nD"
Special Scales Pre-programmed
USER Conversion tables (concentrations and
refractive index) can be created for user
scales.
(None)
USER SCALE
UNIT
Choose from g/100g, %vol, %mas, mol/l,
g/100ml, %, or no unit.
(None)
MODE Choose from 1, 2, 3, S, or T.
(T is only available for 5000i-Plus)
1
Continuous
Measurements:
n
Choose from 1 to 99. 1
Wait Time Choose from 0 to 999. The timing the wait time
starts to count down varies, depending on the
measurement mode.
0
TEMP
CONTROL
Turn on or off in MODE-3. ON
TARGET Temp
Choose from 5 to 75 at a minimum resolution
of 0.01.
20.00℃
Resolution Brix : 0, 0.1, 0.01, 0.005, 0.001
(0.005 and 0.001 are only available for 5000i-Plus.)
0.001(5000i-Plus) 0.01(5000i/9000i)
0.1(7000i)
nD : 1.00, 1.000, 1.0000, 1.00000 1.00000 (5000i-Plus/5000i/9000i)
1.0000 (7000i)
User scale: user-configured (None)
Special scales: see page 57 "Special Scales List"
See page 57 "Special Scales List"
LIMIT BAR
(ON/OFF)
Turn on or off. ON
LIMIT BAR
(upper and lower
limits)
The control range
against which
measurement values
are checked.
Brix -1.000 to 100.000 (5000i-Plus)
-1.00 to 100.00 (5000i/9000i)
-1.0 to 100.0 (7000i)
nD 1.32420 to 1.58000 (5000i-Plus/5000i)
1.29980 to 1.71500 (7000i/9000i)
USER (None)
Special Scales See page 57 "Special Scales List"
To Next Page
Loading...
Need help?
General
