ATEQ D520 - Page 95

Chapter 4 – Functions of the instrument
UM-22100H-U User manual ATEQ D520 Page 85/122
2.14.6. Parameter setting of the strings (LEARNING)
The characters string learning will be done from the special cycles.
First, check or validate in the
CONFIGURATION menu the
BAR CODES function (Yes).
CONFIGURATION
BARCODE : Yes
SECURITY : No
LIGHT
Back to the main menu, and
select the SPE CYCLE menu.
MAIN
MENU
SPE CYCLE: None
CONFIGURATION
SERVICE
Then go to the BAR CODES
function and validate by
ENTER.
SPE CYCLES
Infinite fill
Auto zero
BAR CODE
The unit requires the number
of the test program
corresponding to the character
chain which will be flashed,
validate by ENTER.
MAIN
/BAR
CODE
Pr. Select : 01
The display confirms that the
BAR CODE special cycle is
selected.
MAIN
MENU
RUN PROG. : 01
PARAMETERS
SPE CYCLE: BARCODE
Press START to run the
special cycle. The device
waits for the bar-code (string
characters). The paired
program number is displayed.
CYCLE/P
r :
01
Pr. Select : 1
BARCODE
Then flash the code by using
the bar code reader. The
captured string is displayed.
CYCLE/P
r :
01
Pr. Select : 1
123456789001XXXXXXXX
01 BARCODE
The code is recorded and the
device is ready to run. At each
time this character string is
flashed, the paired program
will be set as active program.
CYCLE/P
r :
01
PRESS = 185.8 mbar
123456789001XXXXXXXX
READY (OK)