Atlas Copco DC 200

Repair, precautions
Maintenance work must be conducted exclusively
by authorised and trained maintenance personnel.
Maintenance works not allowed by Atlas
Copco
Some maintenance activities must be carried out
exclusively by Atlas Copco. If such maintenance
activities are required, consult the Atlas Copco
customer center/Dealer in your area in order to
ensure that they proceed safely.
The following maintenance activities are not
allowed by Atlas Copco:
•
Repairs to the gear
•
Replacing wear sleeves and pick boxes
•
Welding work on the cutter drums
•
Welding work on the gear housing
Changes to the hydraulic
attachment, precautions
WARNING Changes to the hydraulic
attachment
Changes to the hydraulic attachment or the
adapter plate may lead to serious injury.
►
Never carry out any changes to the hydraulic
attachment or the adapter plate.
►
Only use original parts or accessories approved
by Atlas Copco.
►
Modifications that entail new hazards may
require a new procedure for assessing
conformity.
WARNING Injuries due to the use of
incorrect spare parts
The use of incorrect or defective spare parts can
result in risks to personnel as well as damage,
malfunctioning or a total failure of the transverse
drum cutter.
►
Only use original parts or accessories approved
by Atlas Copco.
►
If there are any questions, consult the Atlas
Copco Customer Center/dealer in your area.
Safety and operating instructions DC 200, 400, 600, 1000, 1200, 2000, 2100, 2900
14 © Construction Tools GmbH | 3390 5192 01 | 2016-12-01
Original instructions