Atlas Copco DC 200

Replace round attack pick with knock on
retainer
The following special equipment is required to
replace the round attack picks:
•
Mounting tool for knock on retainer
•
Dismantling tool for knock on retainer
The special equipment is included in the scope of
delivery.
B
A
A. Dismantling tool
B. Knock on retainer
1. Place the dismantling tool (A) with the semi-
circular opening onto the opening of the knock
on retainer (B).
A
B
2. Remove the knock on retainer (B) with a
forceful hammer blow onto the dismantling
tool (A).
3. Pull round attack pick out of the pick box.
4. Clean the pick box.
5. Insert a new round attack pick.
6. Place a new knock on retainer (B) in the
mounting tool (C).
B
C
Note: The retainer of the mounting tool is
magnetic and holds the knock on retainer.
7. Place the mounting tool with the knock on
retainer (B) on the pick shaft (D).
B
D
8. Drive in the knock on retainer with a forceful
hammer blow onto the mounting tool.
DC 200, 400, 600, 1000, 1200, 2000, 2100, 2900 Safety and operating instructions
© Construction Tools GmbH | 3390 5192 01 | 2016-12-01
Original instructions
45