Atlas Copco DC 200

Transport
WARNING Hoist tipping over / hydraulic
attachment falling
The hydraulic attachment is heavy. The hoist/lifting
equipment and/or hydraulic attachment tipping
over or falling may cause serious injury and
material damage.
►
Only transport the hydraulic attachment with
lifting equipment with the right load-bearing
capacity for the weight of the hydraulic
attachment.
►
Only lift and secure the hydraulic attachment
with lifting gear (ropes, chains, shackles etc.)
with the right load-bearing capacity for the
weight to be lifted.
►
Make sure that there is nobody near or under
the suspended hydraulic attachment.
Transport using a crane
The transverse drum cutter is equipped with
transport lugs, for lifting by crane.
◆
Secure the hydraulic attachment with ropes or
chains as shown in the following illustration.
◆
Slowly lift the hydraulic attachment.
Ensure that the transverse drum cutter hangs
straight, if applicable observe any eccentric
centre of gravity.
◆
Place the transverse drum cutter on the
assembly stand.
Safety and operating instructions DC 200, 400, 600, 1000, 1200, 2000, 2100, 2900
22 © Construction Tools GmbH | 3390 5192 01 | 2016-12-01
Original instructions