Assemble and disassemble
rotatable upper part
The following maintenance activities are carried
out in the workshop.
WARNING Risk of accidents due to use of
old parts
Using old parts (old hydraulic hoses, screws or
clips) can lead to accidents, which may in turn
result in severe injuries.
►
Only use new parts.
►
Only use original parts.
WARNING Risk of injury due to negligence
or incorrect lifting procedure
Negligent or incorrect actions during the lifting of
the rotatable upper part can result in severe
injuries.
►
When lifting or lowering the rotatable upper
part, always observe the weight.
►
Always execute all lifting procedures with heavy
parts using suitable lifting gear.
►
If lifting procedures require the application of
physical force, personnel should always lift in
pairs.
►
Wear protective gloves and safety footwear.
Note: You need an assistant who supports you
when disassembling and assembling the rotatable
upper part.
Disassemble rotatable upper part
1. Remove the adapter plate (see chapter
Removing the hydraulic attachment from the
carrier).
2. Lift the transverse drum cutter onto the
assembly stand.
3. Attach lifting equipment to the rotatable upper
part (C) and keep this tight.
6. Lift up the rotatable upper part and set down
carefully on squared timbers or a pallet.
Assemble rotatable upper part
WARNING Risk of injury due to a failure to
observe the requisite tightening torques
A failure to observe the tightening torques can
result in accidents which may lead in turn to severe
personal injuries or damage to property.
►
Tighten the transverse drum cutter with the
requisite tightening torque.
1. Lift the rotatable upper part with a crane and
place on the transverse drum cutter and adjust
on the centre bolt (F).
Safety and operating instructions DC 200, 400, 600, 1000, 1200, 2000, 2100, 2900
52 © Construction Tools GmbH | 3390 5192 01 | 2016-12-01
Original instructions
To Next Page
Loading...