Atlas Copco DC 200

Qualification
Transporting the hydraulic attachment is only
permitted if carried out by people who:
•
are authorised to operate a crane or a forklift
truck according to the applicable national
provisions,
•
know all the relevant national/regional safety
provisions and accident prevention rules,
•
have read and understood the safety and
transport chapter of these Safety and operating
instructions.
First installation and commissioning of the
hydraulic attachment is only permitted if carried out
by people who:
•
are authorised by Construction Tools GmbH,
•
know all the relevant national/regional safety
provisions and accident prevention rules,
•
have read and understood these Safety and
operating instructions.
Installing, maintaining, storing and disposing of
the hydraulic attachment are only permitted if
carried out by people who:
•
know all the relevant national/regional safety
provisions and accident prevention rules,
•
have read and understood these Safety and
operating instructions.
Operating the hydraulic attachment is only
permitted if carried out by qualified carrier drivers.
Carrier drivers are qualified if they:
•
have been trained to operate a carrier
according to the national regulations,
•
know all the relevant national/regional safety
provisions and accident prevention rules,
•
have read and understood these Safety and
operating instructions.
Testing the hydraulic installation is only
permitted if carried out by professionals.
Professionals are people who are authorised to
approve a hydraulic installation for operation
according to the national regulations.
Repairing the hydraulic attachment is only
permitted if carried out by professionals trained by
Construction Tools GmbH. These professionals
must have read and understood these Safety and
operating instructions. They must follow all safety
instructions and guidelines for repair. Otherwise
the operational safety of the hydraulic attachment
is not guaranteed.
Personnel (carrier operator, maintenance
personnel) must receive instructions from the
operator regularly. For the purpose of improved
traceability, the provision of instructions must be
recorded.
Intended use
Only attach the transverse drum cutter to a
hydraulic carrier of a suitable load-bearing
capacity. Read the carrier manufacturer's Safety
and operating instructions before attaching the
transverse drum cutter to the carrier and operating
it. Observe all instructions.
The transverse drum cutter is intended exclusively
for mounting on a hydraulic excavator or, following
agreement with the Atlas Copco Customer Center/
dealer in your area, with another carrier.
The transverse drum cutter serves exclusively to
cut:
•
Rock
•
Concrete (reinforced and non-reinforced)
•
Asphalt
•
Frozen soil
•
Ice
Furthermore, the transverse drum cutter is suitable
for cutting ditches and tunnels. The transverse
drum cutter can be used to a depth of 30 m under
water.
When cutting with the transverse drum cutter,
check the compressive strengths of the rock to be
cut (see chapter Technical specifications).
Intended use also includes adhering to all
specifications contained in this manual.
Any further use which exceeds or is contrary to the
intended use is considered inappropriate use.
Use other than intended
Misusing the transverse drum cutter or the boom
can lead to dangerous situations.
•
Do not use the transverse drum cutter in areas
with a risk for explosions.
•
Do not cut any materials other than those
mentioned in chapter Intended use.
•
Do not carry out any impacting work.
•
Do not operate the transverse drum cutter if
picks are broken.
•
Do not use the transverse drum cutter as a
device for lifting people or materials.
•
Do not use the transverse drum cutter as a
surface for carrying or transporting machines,
materials or tools.
•
Do not use the transverse drum cutter to take
the weight of the carrier.
Claims of any kind as a result of damages arising
from misuse are excluded.
DC 200, 400, 600, 1000, 1200, 2000, 2100, 2900 Safety and operating instructions
© Construction Tools GmbH | 3390 5192 01 | 2016-12-01
Original instructions
9