Atlas Copco DC 200

Storage
◆
Always store the transverse drum cutter:
•
secured on the assembly stand
•
dry, free of dust and free of contamination
•
free of mechanical shocks
•
protected from mechanical damage
◆
Check the general condition of all parts and the
packaging regularly.
Transverse drum cutter
Short storage
Proceed as follows in the case of storage for less
than three month:
◆
Remove the transverse drum cutter from the
carrier (see chapter Removing the hydraulic
attachment from the carrier).
◆
Always store the transverse drum cutter:
•
secured on the assembly stand
•
dry, free of dust and free of contamination
•
free of mechanical shocks
•
protected from mechanical damage
◆
Check the general condition of all parts and the
packaging regularly.
Long storage
For storage of more than 3 months extra
procedures must be performed in addition to short
storage.
In order to guarantee protection of the internal
parts of the hydraulic motor, implement the
following protective measures with respect to the
hydraulic motor:
The measures listed in the following table depend
on the duration of storage and the ambient climate
of the storage site.
Duration of
storage
Climate range
Moderate Tropical Coastal
3 months A B C
6 months B C D
12 months C C D
24 months C D D
Explanation to the measures specified in the table
pertaining to storage:
A No special maintenance measures
necessary. Apply plugs and closures.
B Fill hydraulic motor with hydraulic oil.
C Rinse hydraulic motor with preservation
agent.
D Fill hydraulic motor with preservation agent.
Cutter drums
◆
Remove the round attack picks, if the cutter
drums are stored for an extended period, (see
chapter Replace round attack picks).
◆
Preserve the cutter drums with oil.
Round attack picks
If the transverse drum cutter is stored for an
extended period of more than 4 weeks, detach the
round attack picks because these can corrode with
the cutting material and bond together with the pick
boxes.
◆
Remove the round attack picks (see chapter
Replace round attack picks).
◆
Preserve the round attack picks with oil.
◆
Store the round attack picks protected against
contamination and mechanical damage.
NOTICE Damage due to increased wear
Dust and dirt adhere to oily surfaces and lead to
increased wear.
►
Clean oiled parts before reassembly.
Safety and operating instructions DC 200, 400, 600, 1000, 1200, 2000, 2100, 2900
62 © Construction Tools GmbH | 3390 5192 01 | 2016-12-01
Original instructions