Atlas Copco DC 200

Replace round attack picks with retaining
ring
The following special equipment is required to
replace the round attack picks:
•
Long nose pliers, curved
1. Remove both retaining rings (L) from the pick
shaft one after another using long nose
pliers (M).
L M
2. Pull round attack pick out of the pick box.
3. Clean the pick box.
4. Insert a new round attack pick.
5. Place a new retaining ring (L) on the pick
shaft (N) and rotate the retaining ring opening
downwards (arrow).
L
N
6. Attach the second retaining ring (L) and rotate
the retaining ring opening upward.
180°
L
Safety and operating instructions DC 200, 400, 600, 1000, 1200, 2000, 2100, 2900
48 © Construction Tools GmbH | 3390 5192 01 | 2016-12-01
Original instructions