Atlas Copco DC 200

Transport using a forklift
truck
Always transport the transverse drum cutter whilst
secured to the assembly stand.
WARNING Hydraulic attachment tipping
over
The hydraulic attachment tipping off the fork of the
forklift truck or the assembly stand may cause
serious injury.
►
Place the hydraulic attachment on the assembly
stand.
►
Strap the hydraulic attachment to the assembly
stand using suitable strapping, as shown in the
illustration below.
►
Move the forks of the forklift truck under the
assembly stand so that the centre of gravity is
between the prongs.
◆
Move the forks of the forklift truck under the
assembly stand so that the hydraulic
attachment cannot tip over.
◆
Slowly lift the assembly stand with the hydraulic
attachment.
◆
Transport the assembly stand with the hydraulic
attachment to the location provided for.
Transport using a truck
Always transport the transverse drum cutter whilst
secured to the assembly stand.
WARNING Hydraulic attachment tipping
over / slipping
The hydraulic attachment slipping or tipping over
and falling from the loading area of a lorry may
cause serious injury.
►
Place the hydraulic attachment on the assembly
stand.
►
Strap the hydraulic attachment to the assembly
stand using suitable strapping (see illustration
in chapter Transport using a forklift truck).
►
Place the assembly stand with the hydraulic
attachment on an anti-slip mat.
►
Secure the hydraulic attachment to the loading
area with ropes or chains; use any available
transport lugs.
◆
Secure the hydraulic attachment on the
assembly stand and the loading surface as
shown in the following illustration.
◆
Observe all the applicable national/regional
regulations on securing loads.
DC 200, 400, 600, 1000, 1200, 2000, 2100, 2900 Safety and operating instructions
© Construction Tools GmbH | 3390 5192 01 | 2016-12-01
Original instructions
23