Maintenance
The maintenance work described in the following
sections is necessary for the optimum and fault-
free operation of the hydraulic attachment.
Insofar as regular checks reveal a rapid rate of
wear, it may be necessary to increase the
frequency of maintenance in line with the actual
rate of wear.
In the event of questions regarding maintenance
work and intervals, consult the Atlas Copco
Customer Center/Dealer in your area.
The following maintenance activities are mainly
carried out by the carrier driver. Maintenance
activities that should be carried out in a workshop
are indicated as such.
DANGER Risk of death due to a failure to
observe the maintenance intervals
Delaying or omitting maintenance in contravention
of the fixed maintenance intervals can result in
serious accidents and damage to property.
►
Ensure that all fixed maintenance works and
intervals are adhered to by authorized
maintenance personnel.
►
Always monitor the wear of the individual
components and replace worn parts.
►
Only carry out maintenance activities allowed
by the manufacturer.
►
Contact the manufacturer regarding
maintenance work not allowed by the
manufacturer.
WARNING Risk of injury due to inadequate
safeguards whilst working on the machine
Inadequate safeguarding of the carrier during
maintenance or service work can lead to serious
injuries.
►
Only perform work on the machine when at a
standstill.
►
Depressurise the hydraulic system (see chapter
Depressurising the hydraulic system).
►
Prior to restarting, install all covers, tighten
threaded and safety devices in accordance with
specifications and check that they work.
WARNING Danger of injury due to moving
parts
Rotating components and/or components with
linear movement can cause serious injury.
►
Prior to all maintenance work on moving parts,
switch off the machine and safeguard it against
being switched back on. Wait until all parts have
come to a standstill.
►
When in the hazardous area wear closely fitting
clothes with a minimal tear strength.
WARNING Risk of death due to
unauthorised switching on
An unauthorised switching on of the power supply
during maintenance work results in a risk of severe
injury and even death to those persons in the
hazardous area.
►
Prior to work starting switch off all power
supplies and safeguard against a restart.
Safety and operating instructions DC 200, 400, 600, 1000, 1200, 2000, 2100, 2900
38 © Construction Tools GmbH | 3390 5192 01 | 2016-12-01
Original instructions
To Next Page
Loading...