◆
Turn the transverse drum cutter to the desired
position.
WARNING Hands and fingers being cut
off or hurt
Bores and surfaces can act like a pair of
scissors and cut off or hurt parts of your body.
►
Never use your fingers to check bores or
fitting surfaces.
◆
Fix the transverse drum cutter in the required
position with the bolts and nuts.
◆
Slowly lower the transverse drum cutter onto
the ground.
◆
Tighten all bolts and nuts connecting the
rotatable upper part to the gear housing with
the required tightening torque (see chapter Bolt
connections/Tightening torques).
◆
Fit counter nuts to each bolt.
Note: Working with rotated transverse drum cutter
causes higher forces to be fed to the carrier. Also
the wear of the individual components of the
transverse drum cutter increase.
DC 200, 400, 600, 1000, 1200, 2000, 2100, 2900 Safety and operating instructions
© Construction Tools GmbH | 3390 5192 01 | 2016-12-01
Original instructions
37
To Next Page
Loading...