The transport lug (E) serves as an anchor point for
the lifting gear when transporting the transverse
drum cutter.
Rotatable upper part
The transverse drum cutter is fastened to a
suitable adapter plate on the carrier boom via the
rotatable upper part. The rotatable upper part is
bolted to the adapter plate. Additionally, the
transverse cutter drum can be rotated via the
rotatable upper part relative to the axis of the
boom.
Gear housing
The gear housing contains a spur gear driven by a
hydraulic motor. The gear's drive shafts turn the
cutter drums. The hydraulic motor transfers the
drive moment through the gear to the cutter drums.
Round attack picks
The round attack picks are made of steel and have
a brazed tungsten carbide tip. The round attack
picks are held in the pick boxes.
The appearance of the round attack picks may
deviate from the image shown here.
DC 200, 400, 600, 1000, 1200, 2000, 2100, 2900 Safety and operating instructions
© Construction Tools GmbH | 3390 5192 01 | 2016-12-01
Original instructions
17
To Next Page
Loading...