AudioCodes Mediant 2000 System User Manual

Version 5.2 297 September 2007
SIP User's Manual 6. ini File Configuration
Table 6-7: SIP Configuration Parameters
ini File Field Name
Web Parameter Name
Valid Range and Description
IsRegisterNeeded
For a description of this parameter, refer to 'Proxy & Registration
Parameters' on page 86.
RegistrarIP
For a description of this parameter, refer to 'Proxy & Registration
Parameters' on page 86.
RegistrarName
For a description of this parameter, refer to 'Proxy & Registration
Parameters' on page 86.
GWRegistrationName
For a description of this parameter, refer to 'Proxy & Registration
Parameters' on page 86.
AuthenticationMode
For a description of this parameter, refer to 'Proxy & Registration
Parameters' on page 86.
OOSOnRegistrationFail
For a description of this parameter, refer to 'Proxy & Registration
Parameters' on page 86.
RegistrationTime
For a description of this parameter, refer to 'Proxy & Registration
Parameters' on page 86.
RegistrationTimeDivider
For a description of this parameter, refer to 'Proxy & Registration
Parameters' on page 86.
RegistrationRetryTime
For a description of this parameter, refer to 'Proxy & Registration
Parameters' on page 86.
RegisterOnInviteFailure
For a description of this parameter, refer to 'Proxy & Registration
Parameters' on page 86.
RegistrationTimeThreshol
d
For a description of this parameter, refer to 'Proxy & Registration
Parameters' on page 86.
NumberOfActiveDialogs
Defines the maximum number of active SIP dialogs that are not call
related (i.e., REGISTER and SUBSCRIBE). This parameter is used to
control the Registration / Subscription rate.
The valid range is 1 to 20. The default value is 20.
PrackMode
For a description of this parameter, refer to 'General Parameters' on
page 72.
AssertedIdMode
For a description of this parameter, refer to 'General Parameters' on
page 72.
PAssertedUserName
Defines a 'representative number' (up to 50 characters) that is used as
the User Part of the Request-URI in the P-Asserted-Id header of an
outgoing INVITE (for Tel-to-IP calls).
The default value is NULL.
UseAORInReferToHeader
Defines the source for the SIP URI set in the Refer-to header of
outgoing REFER messages.
 [0] = Use SIP URI from Contact header (default) of the initial call.
 [1] = Use SIP URI from To/From header of the initial call.
UseTelURIForAssertedID
For a description of this parameter, refer to 'General Parameters' on
page 72.

AudioCodes Mediant 2000 System Specifications

General

Brand	AudioCodes
Model	Mediant 2000 System
Category	VoIP
Language	English