Version 5.2 305 September 2007
SIP User's Manual 6. ini File Configuration
Table 6-7: SIP Configuration Parameters
ini File Field Name
Web Parameter Name
Valid Range and Description
TelProfile
Configures the Tel Profile Settings table (refer to 'Tel Profile Settings' on
page 134).
[TelProfile]
FORMAT TelProfile_Index = TelProfile_ProfileName,
TelProfile_TelPreference, TelProfile_CodersGroupID,
TelProfile_IsFaxUsed*, TelProfile_JitterBufMinDelay*,
TelProfile_JitterBufOptFactor*, TelProfile_IPDiffServ*,
TelProfile_SigIPDiffServ*, TelProfile_DtmfVolume,
TelProfile_InputGain, TelProfile_VoiceVolume, N/A, N/A,
TelProfile_EnableDigitDelivery, TelProfile_EnableEC, N/A, N/A,
TelProfile_FlashHookPeriod, TelProfile_EnableEarlyMedia*,
TelProfile_ProgressIndicator2IP*, TelProfile_TimeForReorderTone*;
[\TelProfile]
* = Indicates common parameters used in both IP and Tel profiles.
TelPreference = determines the priority of the Profile (1 to 20, where 20
is the highest preference). If both IP and Tel profiles apply to the same
call, the coders and other common parameters (indicated with an
asterisk) of the preferred Profile are applied to that call. If the preference
of the Tel and IP profiles is identical, the Tel Profile parameters are
applied.
For example:
[TelProfile]
TelProfile 1 =
FaxProfile,1,1,1,40,13,22,33,$$,$$,$$,0,0,0,1,0,0,$$,0,$$,$$;
TelProfile 2 = ModemProfile,2,2,0,40,13,$$,$$,$$,$$,$$,$$,$$,$$,0,0,
0,$$, 0,$$,$$;
[\TelProfile]
Notes:
 For a description of using ini file parameter tables, refer to 'Structure
of ini File Parameter Tables' on page 269.
 Two adjacent dollar signs ('$$') indicates that the parameter's default
value is used.
 The TelProfile index can be used in the Trunk Group table
(TrunkGroup parameter).
 The 'Profile Name' assigned to a Profile index must enable users to
identify it intuitively and easily.
 This parameter can appear up to 9 times (i.e., index = 1 to 9).
To Next Page
Loading...
Need help?
General