SIP User's Manual 316 Document #: LTRT-68806
Mediant 2000 & TP-1610 & TP-260/UNI
Table 6-11: ISDN and CAS Interworking-Related Parameters
ini File Field Name
Web Parameter
Name
Valid Range and Description
CASDelimitersPaddi
ngUsage
Defines the digits string delimiter padding usage per trunk.
[0] (default) = default address string padding: '*XXX#' (where XXX is the
digit string that begins with '*' and ends with '#', when using padding).
[1] = special use of asterisks delimiters: '*XXX*YYY*' (where XXX is the
address, YYY is the source phone number, and '*' is the only delimiter
padding).
CasStateMachineGe
nerateDigitOnTime
For a description of this parameter, refer to 'CAS State Machines' on page
192.
CasStateMachineGe
nerateInterDigitTime
For a description of this parameter, refer to 'CAS State Machines' on page
192.
CasStateMachineDT
MFMaxOnDetectionT
ime
For a description of this parameter, refer to 'CAS State Machines' on page
192.
CasStateMachineDT
MFMinOnDetectionT
ime
For a description of this parameter, refer to 'CAS State Machines' on page
192.
CasStateMachineMa
xNumOfIncomingAd
dressDigits
For a description of this parameter, refer to 'CAS State Machines' on page
192.
CasStateMachineMa
xNumOfIncomingAN
IDigits
For a description of this parameter, refer to 'CAS State Machines' on page
192.
CasStateMachineCol
lectANI
For a description of this parameter, refer to 'CAS State Machines' on page
192.
CasStateMachineDig
itSignalingSystem
For a description of this parameter, refer to 'CAS State Machines' on page
192.
EnableDSPIPMDetec
tors
Enables / disables the gateway's DSP detectors.
[0] = Disable (default).
[1] = Enable.
Notes:
The gateway's Feature Key should contain the “IPMDetector” DSP option.
When = 1, the number of available gateway channels is reduced by a
factor of 5/6. For example, a gateway with 8 E1 spans, capacity is reduced
to 6 spans (180 channels), while a gateway with 8 T1 spans, capacity
remains the same (192 channels).
XChannelHeader
For a description of this parameter, refer to 'General Parameters' on page
103.
AddIEinSetup
For a description of this parameter, refer to 'Configuring the Digital Gateway
Parameters' on page 142.
SendIEonTG
For a description of this parameter, refer to 'Configuring the Digital Gateway
Parameters' on page 142.