Installation and Maintenance Manual 102 LTRT-33443
Mediant SBA
Figure 14-1: Display the IP Address
In case a static IP address needs to be set, use the following command:
i <#> <ip> <subnet> <gateway>
<#> is the interface number – the example above interface number 12 is connected
and can be set.
For example: i 12 10.21.2.164 255.255.0.0 10.21.0.1
A.3 KVM/VGA Systems
After booting from USB, the cmd screen is displayed.
1. Type goRecovry.exe to burn the SSD.
2. When complete, a text message is displayed to remove the USB and reset – remove
the USB, enter exit and validate that the system restarts.
The system boots twice due to the sysprep.
3. After the second boot, you can connect to Windows, set the IP address manually or see
which IP address was received from DHCP.
To Next Page
Loading...
Need help?
General
