Installation and Maintenance Manual 10. Using the DR-SBA Management Interface
Version 1.0.21 79 Microsoft Teams
10.2.5 Configuring Certificates
The following dialog is used to configure the DR-SBA certificate.
To configure certificates:
1. From the Setup menu, select the Setup folder, and then click Direct Routing SBA
Certificate.
Figure 10-10: Configuring Certificates
Certificate configuration is explained in detail in the SBA Wizard section in Chapter 5.
10.2.6 Access List
The following procedure describes how to configure which IP addresses are allowed to
access the SBA Web and RDP. This setup limits access to the SBA part only and not to the
SBC/Gateway part (for the SBC/Gateway access list, use the SBC/Gateway Web interface).
Note: Pay attention to which IP address/subnet you specify. You can accidently block
access to the SBA. If this occurs, use the screen and keyboard to connect to the SBA
locally and open the Web interface locally to fix the access list.
To configure the Access List:
1. From the Setup menu, select the Setup folder, and then click Access List.
To Next Page
Loading...
Need help?
General
