E
Electronic device ID 104
Electronics monitoring power
supply
96
EMERGENCY behaviour 75
EMERGENCY operation 75, 77
EMERGENCY speed 78
EMERGENGY stop 34
Enable functions 99
Enable operation commands 82
Enabling local controls 80
Enclosure protection 10
End position seating 36
End position tolerance 54
Enforce REMOTE control 81
Error - indication on display 19
Error variable 54
Event report 111
F
Factory setting 100
Failure behaviour 73
Failure functions 73
Failure - indication on display 24
Failure operation 73
Failure position 74
Failure source (EMERGENCY
operation)
77
Failure source (failure opera-
tion)
73
Failure source (Interlock) 83
Fault - indication on display 23
Fault signal - configurable 27
Firmware update 102
Firmware version 102
FOC (diagnostic) 108
Frequency (histogram) 117
Frequency-acceleration (histo-
gram)
117
Function check - indication on
display
24
Functions: activate/enable 99
Fuses 122
H
Heater 96
Heater in switch compartment 71
Heater monitoring 96
Heater monitoring time 97
Heater on control unit 71
Heater system 96
Heater system monitoring 96
Histogram 115, 116, 117, 117
Histograms 115
I
Identification 10
Indication light colour 25
Indication lights 25
Indications 19
Indications on display 19
Input current 11
Input signal 11
Inspection certificate 10
Interface (diagnostics) 105
Interlock: 82
Interlock: by-pass 79
Interlock behaviour 83
Intermediate position indica-
tion via LEDs
25
Intermediate positions 48
Internal process setpoint 61
Intrusive 11
Inverse operation 61
L
Language in the display 17
LEDs (indication lights) 25
Limit seating 36
Limit setting range 55
Limit switching 39
Local actuator operation 13
Local control 13
Local controls 13
Local setting 14
Local Stop 84
Local stop: by-pass 79
Loss of process setpoint 61
Loss of signal 73, 74
Loss of signal process set-
point
61
133
Actuator controls
ACV 01.2/ACVExC 01.2 Index
To Next Page
Loading...
Need help?
General
