configure terminal
interface Ethernet <port> or interface vlan <1–4094>
2. At the command prompt, enter the following command:
[default] duplex [port <portlist>] {full|half|auto}
Variable definitions
The following table describes the parameters for the duplex [port <portlist>] command.
Variable Value
port<portlist> Specifies the port number to configure the duplex
mode. Enter the port number you want to configure,
or ALL to configure all ports simultaneously.
Important:
If you omit this parameter, the system uses the
port number you specified in the interface
command.
full|half|auto Sets duplex to:
• full — full-duplex mode
• half — half-duplex mode
• auto — autonegotiation
Important:
When you set the duplex mode for
autonegotiation, ensure that the other side of
the link is also set for autonegotiation.
default Sets the duplex operation for a port to the factory
default duplex value.
High speed flow control
The high speed flow control feature lets you control traffic and avoid congestion on the gigabit full-
duplex link. If the receive port buffer becomes full, the switch issues a flow-control signal to the
device at the other end of the link to suspend transmission. When the receive buffer is no longer full,
the switch issues a signal to resume the transmission. You can set the flow control mode to
Asymmetric or disabled.
Managing Ethernet ports using ACLI
100 Getting Started with Avaya ERS 3500 Series July 2015
Comments on this document? infodev@avaya.com
To Next Page
Loading...
