Avaya 3500 series - Configuring Leds to Blink on the Display Panel

Example
The following figure provides a sample of the show sys-info command.
Switch#show sys-info
Operation Mode: Switch
MAC Address: B4-A9-5A-FD-6C-00
Reset Count: 58
Last Reset Type: Software Download
Autotopology: Enabled
Pluggable Port 47: None
Pluggable Port 48: None
Pluggable Port 49: None
Base Unit Selection: Non-base unit using rear-panel switch
sysDescr: Ethernet Routing Switch 3549GTS
HW:R0A FW:1.0.0.11 SW:v5.2.0.037
Mfg Date:20130619 HW Dev:none
Serial #: SDNI49GA0012
Operational Software: FW:1.0.0.11 SW:v5.2.0.037
Installed software: FW:1.0.0.11 SW:v5.2.0.037
Operational license: Base software
Installed license: Base software
sysObjectID: 1.3.6.1.4.1.45.3.80.7
sysUpTime: 1 day, 04:31:04
sysNtpTime: NTP not synchronized.
sysServices: 6
sysContact:
sysName: 3549GTS
sysLocation:
Stack sysAssetId:
Unit sysAssetId:
Configuring LEDs to blink on the display panel
Use this procedure to set the LEDs on the display panel to blink to identify a particular unit.
Procedure
1. Enter Privileged EXEC mode:
enable
2. At the command prompt, enter the following command:
blink-leds [off | time <1–10> | unit <1–8>]
Variable definitions
The following table describes the parameters for the blink-leds command.
Variable
Value
off Sets the LEDs to stop blinking
time <1–10> Indicates the duration, in minutes, for the LEDs to
blink to identify the unit.
RANGE: 1 to 10 minutes
Table continues…
Configuring the switch using ACLI
64 Getting Started with Avaya ERS 3500 Series July 2015
Comments on this document? infodev@avaya.com