Avaya 3500 series - AAUR Configuration

show stack-info
Example
The following figure provides a sample of the show stack-info command.
Switch#show stack-info
Unit# Switch Model Pluggable Pluggable Pluggable Pluggable SW Version
Port Port Port Port
----- ---------------- --------- --------- --------- --------- ----------
1 3549GTS (47) SX (48) SX (49) SR v5.2.0.037
2 3524GT-PWR+ (21) SX (22) SX (23) SX (24) SX v5.2.0.037
3 3526T-PWR+ (25) SX (26) SX v5.2.0.037
AAUR configuration
Use ACLI procedures in the following sections to manage and configure Agent Auto Unit
Replacement (AAUR). You can currently manage this functionality only through ACLI.
Enabling or disabling AAUR
Use this procedure to enable or disable AAUR.
Note:
AAUR is recommended and enabled by default.
Before you begin
AAUR requires a stack configuration
About this task
You can use the AAUR feature to ensure that all units in a stack run the same software image.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. To enable AUR, enter the following command:
stack auto-unit-replacement-image enable
3. To disable AUR, enter the following command:
no stack auto-unit-replacement-image enable
4. To default AUR, enter the following command:
default stack auto-unit-replacement-image enable
The default is enabled.
Configuring the switch using ACLI
July 2015 Getting Started with Avaya ERS 3500 Series 83
Comments on this document? infodev@avaya.com