Avaya 3500 series - Configuring IP Office Script Using EDM

Remote Access Setting field descriptions
The following table describes the fields on the Remote Access Setting tab.
Name Description
Telnet Remote Access Setting Specifies the remote access settings for telnet
sessions:
• Access: Allows or disallows telnet access to the
switch
• Use List : Enables (Yes) or disables (No) the use
of listed remote Telnet information.
SNMP Remote Access Setting Specifies SNMP remote access settings:
• Access: Allows or disallows SNMP access to the
switch
• Use List : Enables (Yes) or disables (No) the use
of listed remote SNMP information.
Web Page Remote Access Setting Specifies web page remote access settings
• Use List: Enables (Yes) or disables (No) the use
of listed remote web page information.
SSH Remote Access Setting Specifies SSH access settings:
• Access: Allows or disallows SSH access to the
switch
• Use List : Enables (Yes) or disables (No) the use
of listed remote SSH information.
Configuring IP Office script using EDM
Use the following procedure to configure IP Office in default or verbose mode using run scripts.
Note:
When executing the script using EDM, do not run other commands while the script is in
progress, because this slows down the execution. EDM can time-out while waiting for a
response; even when a time-out occurs, the script execution continues on the switch.
Procedure
1. From the navigation tree, double-click Administration.
2. In the Administration tree, double-click Run Scripts.
The IP Office Script work area displays.
3. In the Mode work area, from the Run Script Mode dialog box, select default to execute the
script in the default mode or select verbose to modify the predefined values.
Configuring the switch using EDM
July 2015 Getting Started with Avaya ERS 3500 Series 119
Comments on this document? infodev@avaya.com