show cli {info | list | mode | password [type | unit <1–8>]}
Example
The following figure provides a sample of the show cli command.
switch>show cli info
Inactivity Timeout: 15 minute(s)
Login Timeout: 1 minute(s)
Login Retries: 3
More: True
Screen Lines: 23
Variable definitions
The following table describes the parameters for the show cli command.
Variable Value
info Displays general Console settings
list Lists CLI tree
mode Displays information about current ACLI mode
password [type] Displays the current password type configured for
serial console and Telnet access to the stack, or
standalone switch. Values include:
• local — the system local password is used
• none — no password is used
• radius — RADIUS password authentication is used
• tacacs — TACACS+ AAA services are used
password [unit <1–8>] Displays current ACLI user names and passwords
for a specific unit or all units.
Displaying system information
Display the current system characteristics.
Important:
You must enable and configure SNTP to display GMT time. Refer to Simple Network Time
Protocol (SNTP) on page 69 for more details.
Procedure
1. Enter Privileged EXEC mode:
enable
2. At the command prompt, enter the following command:
show sys-info
Configuring the switch using ACLI
July 2015 Getting Started with Avaya ERS 3500 Series 63
Comments on this document? infodev@avaya.com
To Next Page
Loading...
