Procedure
1. From the navigation tree, double-click Power Management.
2. In the Power Management tree, double-click Energy Saver.
3. In the work area, click the Energy Saver Globals tab.
4. Select the EfficiencyModeEnabled check box.
5. Click Apply.
6. On the toolbar, you can click Refresh to update the work area data display.
Disabling AES efficiency mode using EDM
Use the following procedure to disable AES efficiency mode for the switch.
When enabled, AES efficiency mode enables AES globally and for each port, enables AES PoE
power save mode, and configures AES scheduling to predetermined values (on time 18:00 and off
time 07:30 daily).
Before you begin
• Disable AES globally.
Procedure
1. From the navigation tree, double-click Power Management.
2. In the Power Management tree, double-click Energy Saver.
3. In the work area, click the Energy Saver Globals tab.
4. Clear the EfficiencyModeEnabled check box.
5. Click Apply.
6. On the toolbar, you can click Refresh to update the work area data display.
AES schedule configuration using EDM
Use the information in this section to configure a time interval for the switch to enter lower power
states.
Configuring the AES schedule on time using EDM
Use the following procedure to configure the start of a time interval for the switch to enter lower
power states. The time interval can span a complete week, a complete weekend, multiple days, or
be configured within an individual day.
Before you begin
• Disable AES globally.
Configuring the switch using EDM
July 2015 Getting Started with Avaya ERS 3500 Series 143
Comments on this document? infodev@avaya.com
To Next Page
Loading...
