AUR configuration
This section describes ACLI commands used in Auto Unit Replacement (AUR) configuration.
Enabling or disabling AUR
Use this procedure to enable or disable AUR on the switch, or to set the AUR configuration to the
default value.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. To enable AUR, enter the following command:
stack auto-unit-replacement enable
3. To disable AUR, enter the following command:
no stack auto-unit-replacement enable
4. To default AUR, enter the following command:
default stack auto-unit-replacement enable
Displaying AUR
Use this procedure to displays the current AUR settings.
Procedure
1. Enter Privileged EXEC mode:
enable
2. At the command prompt, enter the following command:
show stack auto-unit-replacement
Example
The following figure provides a sample of the show stack auto-unit-replacement command.
switch#show stack auto-unit-replacement
Auto Unit Replacement Auto-Resorte: Enabled
Auto Unit Replacement Auto-Save: Enabled
UNIT # LAST CONFIG-SAVE TIME-STAMP READY FOR REPLACEMENT
1 3 days 10:23:02 Yes
2 0 days 00:01:40 NO
3 3 days 10:12:33 Yes
6 3 days 10:12:34 NO
8 3 days 10:12:35 Yes
Configuring the switch using ACLI
80 Getting Started with Avaya ERS 3500 Series July 2015
Comments on this document? infodev@avaya.com
To Next Page
Loading...
