configure terminal
interface Ethernet <port> or interface vlan <1–4094>
2. At the command prompt, enter the following command:
[default] speed [port <portlist>] {10|100|1000|auto}
Variable definitions
The following table describes the parameters for the speed [port <portlist>] command.
Variable Value
default Sets the speed of the port to the factory default
speed.
port <portlist> Specifies the port numbers to configure the speed.
Enter the port numbers to be configured.
Important:
If you omit this parameter, the system uses the
port number you specified in the interface
command.
10|100|1000|10000|auto Sets speed to:
• 10 — 10 Mb/s
• 100 — 100 Mb/s
• 1000 — 1000 Mb/s or 1 Gb/s
• 10000 — 10000 Mb/s or 10 Gb/s
• auto — autonegotiation
Important:
When you set the port speed for
autonegotiation, ensure that the other side of
the link is also set for autonegotiation.
Specifying duplex operation for a port
Specify duplex operation as full-duplex mode , half-duplex mode, or auto-negotiated. You can also
reset duplex operation for a port to the factory default duplex value.
Procedure
1. Enter Interface Configuration mode:
enable
Specifying duplex operation for a port
July 2015 Getting Started with Avaya ERS 3500 Series 99
Comments on this document? infodev@avaya.com
To Next Page
Loading...
