Avaya 3500 series - Setting Port Speed and Duplex

Naming ports
You can name ports, change the name, clear the name or reset the port name to an empty string.
Procedure
1. Enter Interface Configuration mode:
enable
configure terminal
interface Ethernet <port> or interface vlan <1–4094>
2. At the command prompt, enter the following command:
[no] [default] name [port <portlist>] <LINE>
Variable definitions
The following table describes the parameters for the name [port <portlist>] command.
Variable Value
port<portlist> Specifies the port numbers to be named.
Important:
If you omit this parameter, the system uses the
port number you specified in the interface
command.
<LINE> Specifies the name of the port using up to 26
alphanumeric characters.
no Clears the port names and resets the field to an
empty string.
default Clears the port names and resets the field to the
default value (an empty string).
Setting port speed
Set the speed of a port. Ports can be set to a speed of 10 Mb/s, 100 Mb/s, 1000 Mb/s (or 1 GB/s), or
auto-negotiated.
Procedure
1. Enter Interface Configuration mode:
enable
Managing Ethernet ports using ACLI
98 Getting Started with Avaya ERS 3500 Series July 2015
Comments on this document? infodev@avaya.com