Chapter 8: Configuring a TFTP server
Setting TFTP parameters
You can display the IP address of the TFTP server and assign an IP address to the TFTP server.
For procedures to copy a configuration file to the TFTP server, or copy a configuration file from the
TFTP server to the switch to use to configure the switch, see Fundamentals of Avaya Ethernet
Routing Switch 3500 Series, NN47203-102.
Displaying the default TFTP server
Display the IP address of the server used for all TFTP-related transfers.
Procedure
1. Enter Privileged EXEC mode:
enable
2. At the command prompt, enter the following command:
show tftp-server
Example
The following figure provides a sample output of the show tftp-server command.
switch#show tftp-server
TFTP Server IP address: 172.16.3.2
Assigning or clearing the TFTP address
Assign or clear the address for the switch to use for TFTP services.
Procedure
1. Enter Global Configuration mode:
enable
92 Getting Started with Avaya ERS 3500 Series July 2015
Comments on this document? infodev@avaya.com
To Next Page
Loading...
