Section Number of writes
----------------------------------------------------------------------------
Diagnostics Image: 2
Agent Image: 14
Config Area: 471
Auxiliary Config Area: 469
CRC Block : 472
---------------------------------------------------------------------------
* Number of minimum guaranteed writes: 100 000
---------------------------------------------------------------------------
The following is an example for stacked units.
----------------------------------------------------------------------------
FLASH Write History Unit 1:
----------------------------------------------------------------------------
Section Number of writes
----------------------------------------------------------------------------
Diagnostics Image: 0
Agent Image: 3
Config Area: 22
Auxiliary Config Area: 22
CRC Block : 22
---------------------------------------------------------------------------
* Number of minimum guaranteed writes: 100 000
---------------------------------------------------------------------------
----------------------------------------------------------------------------
FLASH Write History Unit 2:
----------------------------------------------------------------------------
Section Number of writes
----------------------------------------------------------------------------
Diagnostics Image: 0
Agent Image: 3
Config Area: 21
Auxiliary Config Area: 21
CRC Block : 21
---------------------------------------------------------------------------
* Number of minimum guaranteed writes: 100 000
---------------------------------------------------------------------------
Variable definitions
The following table describes the parameters for the show flash history command.
Variable definition
Variable
Value
unit <1 –8 > Provides information from the specified unit 1 to 8. If
no unit is specified, the number of writes for all
stacked units displays.
Configuring the switch using ACLI
July 2015 Getting Started with Avaya ERS 3500 Series 91
Comments on this document? infodev@avaya.com
To Next Page
Loading...
