------------- ------------- ---------------
Stack IP Address: 172.16.120.10 0.0.0.0
Switch IP Address: 172.16.120.12 172.16.120.12 0.0.0.0
Switch Subnet Mask: 255.255.255.0 255.255.255.0 0.0.0.0
Default Gateway: 172.16.120.1 172.16.120.1 0.0.0.0
switch>
Variable definitions
The following table describes the parameters for the show ip command.
Variable Value
bootp mode Displays BootP-related IP information.
default-gateway Displays the IP address of the default gateway.
address Displays the current IP address.
switch | stack | unit <1–8> Specifies the current IP address of the switch or
stack or specified unit.
dns Displays the DNS configuration.
Displaying IP address information
Use this procedure to display the IP configurations, switch address, subnet mask, and gateway
address.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. At the command prompt, enter the following command:
show ip address
Example
The following figure displays a sample output for the show ip address command.
switch>show ip address
Configured In Use Last BootP/DHCP
------------- ------------- ---------------
Stack IP Address: 172.16.120.10 0.0.0.0
Switch IP Address: 172.16.120.12 172.16.120.12 0.0.0.0
Switch Subnet Mask: 255.255.255.0 255.255.255.0 0.0.0.0
Note:
The Router and DNS IP addresses are global, or common. Addresses and pools that do not
have Router and DNS addresses configured within them use these global addresses.
Displaying IP address information
July 2015 Getting Started with Avaya ERS 3500 Series 45
Comments on this document? infodev@avaya.com
To Next Page
Loading...
