Viewing the agent and diagnostic software load status using EDM
Use this procedure to display the currently saved and operational software status for agent and
diagnostic loads for an individual switch.
Procedure
1. In the navigation tree, double-click Edit.
2. In the Edit tree, click File System.
3. In the work area, click the Boot Image tab to view the software status.
Boot Image tab field descriptions
The following table describes the fields on the Boot Image tab.
Name Description
Unit # Software Image version Indicates the operational agent software image for
the switch.
Unit # Software Image in flash Indicates the saved agent software image for the
switch.
Unit # Diag Image version Indicates the operational diagnostic software image
for the switch.
Unit # Diag Image in flash Indicates the saved diagnostic software image for
the switch.
Configuring SNTP using EDM
Use this procedure to configure Simple Network Time Protocol (SNTP).
Procedure
1. In the navigation tree, click Edit.
2. In the Edit tree, click SNTP/Clock.
3. In the work area, click the Simple Network Time Protocol tab.
4. In the PrimaryServerInetAddressType section, click a radio button.
5. In the PrimaryServerInetAddress dialog box, type a value.
6. In the SecondaryServerInetAddressType section, click a radio button.
7. In the SecondaryServerInetAddress dialog box, type a value.
8. In the State section, click a radio button.
9. In the SyncInterval dialog box, type a value.
Configuring the switch using EDM
July 2015 Getting Started with Avaya ERS 3500 Series 131
Comments on this document? infodev@avaya.com
To Next Page
Loading...
